In energy and process equipment investments or revisions, establishing efficient systems with the right parameters will not only provide profits to the investor but also contribute to ecological awareness by reducing the carbon footprint.
ENEVA can provide consulting services in the following areas for investment and revision.
COGENERATION AND TRIGENERATION SYSTEMS
Cogeneration and trigeneration systems, which provide electricity, heating, and cooling from the same source, are supported by our firm with all necessary feasibility, construction, and operational engineering consulting services during the investment phase and afterwards.
DESIGNS FOR BOILERS, PRESSURE VESSELS, AND AUTOCLAVES
The designs for boiler and autoclave equipment required for steam, hot oil, or hot water production, which is the most common form of heat transfer in industrial facilities, take into account efficiency, reliability, and longevity.
COMPLEX STEAM, HOT OIL, AND HOT WATER SYSTEM PROJECTING
The design of the piping networks, equipment selection, and all necessary thermal + static + dynamic calculations required for the distribution of heat utilized by facilities to consumers fall within our company's area of expertise.
DESIGNS FOR WASTE HEAT BOILERS AND ECONOMIZERS
Designs are carried out for all areas where waste heat is present. Especially, our solutions cater to cogeneration systems, cement factories, glass factories, and many other industrial facilities. Careful consideration is given to ensure that the negative impact on the existing system remains at minimal levels when utilizing waste heat.
WASTE HEAT-BASED ORC ELECTRICITY GENERATION PROJECTS
In energy-intensive industries (such as glass, steel, cement, etc.), when waste heat cannot be used as process heat or cooling, electricity generation based on ORC (Organic Rankine Cycle) becomes essential. Organic fluids with evaporation temperatures lower than that of water vapor are used in the system, thereby efficiently converting low-quality waste heat sources into added value. Our company can provide engineering services throughout all stages of these types of investments, from feasibility to construction and operation.
CUSTOM HEAT EXCHANGER DESIGNS
Heat transfer (heating, cooling, cooking, etc.) forms the basis of most processes in industrial production. Therefore, there is a wide variety of heat exchanger types available. Our company offers design, repair, or improvement services for all types of heat exchangers by combining years of experience with current literature.
WASTE HEAT EQUIPMENT FOR BIOGAS AND LANDFILL GAS SYSTEMS
Special heat exchangers used in wastewater treatment systems (such as digester sludge heating exchangers) are designed according to technical requirements.
BIOGAS OR LANDFILL GAS DEWATERING SYSTEMS
Removing moisture from biogas or landfill gas before its use in engines or boilers extends the life of the system due to condensation and increases the lower calorific value of the fuel, thus enhancing overall efficiency. Such systems can be designed as packaged units along with a complete cooling system.
COAL AND BIOMASS COMBUSTION SYSTEMS
In today's conditions, the complete design of facilities required to produce hot oil, steam, or hot water using the low-cost fuels of coal and biomass can be carried out.
HEAT PUMP SYSTEMS
Heat pump systems are frequently used in processes requiring cooling. Heat pump technology, which allows for the recovery of energy from lower temperature sources and the production of heating from this energy, can be utilized effectively.
ENEVA provides consultancy and engineering services for a wide range of projects in energy and process equipment. Our experienced team can guide you from the feasibility stage through the operational phase, ensuring optimal design and efficient use of resources.
